Abrasives & Power Tools

Morse Taper Adaptors For use with Magtron broaching units, drill presses, lathes etc. Bore diameter: 20mm. Overall length: 156mm..... >>

M2 Multi-Tooth Milling Cutter Set Short Series Shank diameter: 19mm/3/4”. Depth of cut: 25mm. Bore: 6mm. Overall length: 60mm. Compatible with all magnetic drilling and broaching units. Complete with pilot pin and fitted case. Sizes: 14, 16, 18, 20, 22 and 24mm..... >>

M2 Multi-Tooth Milling Cutters Proven value and success based upon the low energy required to cut more holes accurately with extended tool life. The cutter is designed to enable a faster feed rate with lower cutting resistance, resulting in consistency of finish and tolerance. Sizes available: 2 - 52mm diameter short and 13 - 52mm diameter long s.... >>

Pilot Pins For use with all multi-tooth milling cutters with 6mm bore. Pilots locate into pre-drilled pilot holes ensuring positional accuracy of the cutter. Suitable for 'blind' or 'through' pilot holes, pin will retract into cutter adaptor on 'bottoming'. Short series = 77mm. Long series = 102mm. * For 12mm cutters only.... >>